Make sure you have a good variety of sockets. Some of the bolts are tricky to reach, and having the right tools can save a lot of time.
7 Likes
I did this last month! It took me longer than expected because of rust. Next time, I’ll definitely use more penetrating oil ahead of time.
It’s funny how a small thing like penetrating oil can save you hours. A few minutes of prep can go a long way!
6 Likes
Good point, but be careful not to over-apply it! You don’t want oil dripping when you’re working.
If I remember correctly, you should at least do this once every few years to ensure safety. Just did mine last summer, and I feel a huge difference in handling.
Absolutely, proactive maintenance is key! I’ve also noticed better performance since I replaced mine.
4 Likes
Anyone have tips for dealing with stubborn bolts? I’m worried about snapping one during the replacement.
I always use a breaker bar for stubborn bolts! It gives you that extra leverage. Just be gentle so you don’t snap them.
5 Likes
That’s a solid tip! I’ll keep that in mind for my next project. Thanks!
Also, be prepared to curse a little. Sometimes these bolts seem to have a mind of their own, but it’s usually worth it in the end!
Definitely! Just tackled mine and had a moment where I thought I’d give up. But powering through felt fantastic afterward!
2 Likes
Replacing sway bar links can improve your Silverado’s handling significantly, but there are some common issues to watch out for afterwards. Make sure everything is tightened to spec or you might hear some rattling noises.
Absolutely! If you’re hearing clunks or pops, it might mean the links aren’t installed correctly. Double-check your work to be sure they’re seated properly!
I just replaced mine and noticed a slight improvement initially, but recently my handling feels off. What could be causing that?
It could be due to improper alignment after the installation. Have you checked your alignment since replacing the sway bar links? It’s a common oversight.
Also, if your sway bar bushings are worn out, they can lead to more noise and handling issues too. Always a good idea to inspect them when you’re replacing links.
Sway bar installation can be tricky! I found a video that helped clarify some steps. Anyone else bumped into alignment issues post-install?
Definitely! I learned the hard way that neglecting alignment can turn a quick fix into a more expensive problem. Always check!
Could also be that the replacements are subpar quality? I went with aftermarket links and they started to rattle within a month. Check the brand too!
3 Likes
That’s a great point! Always use quality parts when doing any suspension work. It can save you a lot of hassle long-term.
3 Likes